The University of Texas at Austin
Contact Us | For Staff

Design & Construction Standard Detail Drawings

All Standard Detail Drawings presented herein are intended to assist architects, engineers, other design professionals, contractors and UT staff in understanding the preferences of The University of Texas at Austin in the development, maintenance, construction and repair of its facilities. These Detail Drawings are intended to be used as guidelines. Detail Drawing documents require modification to meet the conditions and appurtenances of each project; therefore the legal responsibility for project document preparation shall continue to reside with the Design Professional. Refer to the Welcome Page for additional requirements. The Detail Drawings were created in AutoCAD 2007 file format; AutoCAD is a registered trademark of Autodesk Inc.

Please Note: These Detail Drawing documents are for use by The University of Texas at Austin, its consultants and contractors and remain the property of The University of Texas at Austin at all times.

Division 22: Plumbing

Section Title
P-22-1-3 FLOOR DRAIN INSTALLATION DETAIL
P-22-1-4 FLOOR DRAIN INSTALLATION DETAIL
P-22-1-12 FLOOR DRAIN INSTALLATION DETAIL
P-22-1-13 FLOOR DRAIN INSTALLATION DETAIL
P-22-2-2 PIPE SUPPORT DETAIL
P-22-2-5 PIPE SUPPORT DETAIL
P-22-2-6 MODULAR COMPRESSION PIPE SEAL AND SLEEVE DETAIL
P-22-2-7 PIPE SLEEVE DETAILS
P-22-2-8 WATER, WASTE & VENT PIPING HANGERS & SUPPORTS DETAIL
P-22-5-1 LAVATORY & SINK CONNECTION DETAIL
P-22-5-5 LAVATORY & SINK CONNECTION DETAIL
P-22-5-6 DETAIL: LAB SINK CONNECTION

Division 23: Heating, Ventilating and Air Conditioning

Section Title
M-23-1-5 TYPICAL BRANCH DUCT WITH 45° CLINCH TAP DETAIL
M-23-1-6 TYPICAL BRANCH DUCT WITH CONICAL TAP DETAIL
M-23-1-10 LINED SOUND PLENUM
M-23-1-19 CEILING FIRE DAMPER DETAIL
M-23-1-20 FIRE DAMPER INSTALLATION DETAIL
M-23-1-28 LATERAL MIXING TEE DETAIL
M-23-1-32 VAV FUME HOOD DETAIL (BUILDINGS WITH PNEUMATIC CONTROLS)
M-23-3-1 WATER PIPING HANGERS AND SUPPORTS DETAIL
M-23-3-2 PIPE SLEEVE DETAIL
M-23-3-3 WATER PIPING HANGERS AND SUPPORTS DETAIL
M-23-3-4 PIPE THRU ROOF DETAIL
M-23-4-2 STEAM HEATING COIL PIPING DIAGRAM REHEAT POSITION
M-23-4-2-A STEAM HEATING COIL PIPING DIAGRAM PREHEAT POSITION
M-23-4-8 PIPING SCHEMATIC: STEAM COIL
M-23-4-10 SERIES CHILLED WATER COIL PIPING DIAGRAM
M-23-4-17 CHILLED WATER INSULATION DETAIL AT AHU COIL
M-23-4-18 CONDENSATE DRAIN DETAIL
M-23-4-19 SCHEMATIC AIR BLEED/TEST VALVE SCHEMATIC
M-23-4-23 PIPING DIAGRAM: STEAM TRAP AT END OF MAIN
M-23-4-25 INSTRUMENT TAPS IN PIPING DETAIL
M-23-4-27 SPLIT CHILLED WATER COIL PIPING DIAGRAM
M-23-4-31 INSTRUMENTATION & MISCELLANEOUS PIPING TAPS (FOR WATER BELOW AMBIENT TEMP)
M-23-4-34 COOLING COIL MOUNTING DETAILS
M-23-5-8 STEAM CONDENSATE TANK & DUPLEX PUMP DETAIL
M-23-5-10 END SUCTION PUMP PIPING DETAIL
M-23-6-1 AHU - FRONT ACCESS FILTER HOUSING DETAIL
M-23-8-3 MIXING LATERAL CONTROL DIAGRAM
M-23-8-6 LOW TEMPERATURE SAFETY MOUNTING DETAIL
M-23-8-22 THERMOSTAT & DAMPER CONTROLLER ASSEMBLY DETAIL
M-23-8-23 THERMOSTAT & DAMPER CONTROLLER ASSEMBLY DETAIL

Table of Contents